PNP transistors consist of three cores: an emitter (output) that is conductive, a base, and a collector that is conductive with a neutral (ground) core. In this mode, transistors operate as an anode-collector (A-C) circuit. NPN transistors work by applying a voltage to the anode (positive) terminal through the base core, while decreasing the resistance between the emitter and collector. NPN transistors consist of three cores: an emitter (output) that is conductive with a neutral (ground) core, a base, and a collector that is also conductive with a neutral core. Transistors are devices used in electronic circuits to control signals and power. The key wires to take note of are solid red, black and blue wires.NPN and PNP are two different modes of operation for transistors. NOTE the dotted line in the following diagram is optional and may or may not be required, depending on your hardware/setup. Many modern PLC input cards can be configured and wired to be either ‘sinking’ or ‘sourcing’ although it will usually necessitate all inputs on a particular input card being configured the same. Less common nowadays are input cards that ‘source’, these were popular in Asia and require the NPN type of sensor in order to operate correctly. Most common in Europe is the ‘sinking’ type of input, these will be used with the PNP sensor as shown below. It is therefore important to identify the type of sensor to be used with the PLC card based on the PLC manufacturer’s documentation and / or wiring diagrams. It is worth mentioning, that whilst the terms sinking / sourcing and positive / negative logic are well known in some industries, they are not always commonly used terms. Two types of input cards exist, those that ‘sink’ current (also known as positive logic) and those that ‘source’ current (also known as negative logic). When selecting a sensor to be used with a PLC, it is very important that the sensor matches the type of PLC input card to be used. Use with a programmable logic controller (PLC). PNP sensors tend to be more commonly used. When used in a traditional relay type control circuit, it is normally possible to use either the PNP or the NPN type of sensor as shown below. The selection of a PNP sensor verses an NPN sensor is determined by the nature of the circuit the device is to be used in. Further learning material regarding PNP and NPN transistors can be found online from several sources. However, for ease of understanding please see attached a page extracted from our Practical Aspects book, showing (in brief) transistor terminology and circuit diagrams. Please note that the subject of this FAQ is specifically related to wiring PNP/NPN outputs for sensors, not to give a detailed understanding of transistor technology. a PNP sensor may be either N/O or N/C as can an NPN be either N/O or N/C. Refer to attached document for simple explanation of the two.Ī key point to observe is that PNP and NPN has nothing to do with whether the sensor is normally open (N/O) or normally closed (N/C), i.e. The difference is a result of the internal circuit design and type of transistors used. Two specific types of 3 wire sensors are available: PNP and NPN. Solid state electronic components such as transistors are used to switch the output of the sensor upon detection of an object. The term solid state refers to the type of components used within the sensor. Most industrial proximity sensors (inductive, capacitive, ultrasonic and photoelectric) are solid state.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |